Start the I2C Bus as Slave on address 9 If (x > 5) x = 0 // `reset x once it gets 6Īnd here is the slave code that interprets the characters sent from the master: // Include the required Wire library for I2C#include Wire.endTransmission() // stop transmitting Wire.beginTransmission(9) // transmit to device #9 First, let's take a look at the master code: // Include the required Wire library for I2C#include Serial.The following code is split in two parts: the master code and the slave code, which run on two different Arduinos. Serial.printf('Register value: %04x ', _builtin_bswap16(buf)) įor an explanation on why we need _builtin_bswap16(), see How to print 16-bit uint16_t as four hex digits in Arduino Option 2: Reading the register into an uint8_t array const uint8_t SLAVE_I2C_ADDRESS = 0b1010 Wire.requestFrom(SLAVE_I2C_ADDRESS, 2) // This register is 16 bits = 2 bytes longĭelay(5) // Wait for data to be available Wire.beginTransmission(SLAVE_I2C_ADDRESS) Option 1: Reading the register into an uint16_t (recommended) const uint8_t SLAVE_I2C_ADDRESS = 0b1010 Ĭonst uint16_t SLAVE_I2C_REGISTER_ADDRESS = 0x50 We will provide a full example with error handling in a followup post. This is a minimal example so it creates minimal confusion for the reader. Additionally, we wait for data using delay() instead of Wire.available(). Note that this code does not implement error handling for the sake of simplicity.

In my opinion, it’s most efficient to just try out the standard way of reading a register and start from there. Note that some devices like the LAN9303 have a slightly different addressing scheme or other peculiarities.

It will work with almost all I2C devices like EEPROMs, ADCs and others, provided you have the correct. The following code demonstrates how to read a register that is 2 bytes (16 bits) long over I2C.

Where is arduino wire library